General Description
3. General DescriptionA: CAUTION
^ Supplemental Restraint System "Airbag"
The airbag system wiring harness is routed near the transmission control module (TCM).
CAUTION:
^ All airbag system wiring harness and connectors are colored yellow. Do not use electrical test equipment on these circuit.
^ Be careful not to damage the airbag system wiring harness when performing diagnostics and servicing the TCM.
^ Measurement
When measuring the voltage and resistance of the ECM, TCM or each sensor, use a tapered pin with a diameter of less than 0.64 mm (0.025 inch) in order to avoid poor contact. Do not insert the pin more than 6.5 mm (0.256 inch).
B: INSPECTION
1. BATTERY
Measure the battery voltage and specific gravity of electrolyte.
Standard voltage: 12 V or more
Specific gravity: Above 1.260
2. TRANSMISSION GROUND
Make sure that the ground terminal bolt is tightened securely.
^ Chassis side
Tightening torque: 13 Nm (1.3 kgf-cm, 9.4 ft. lbs.)
3. ATF LEVEL
Make sure the ATF level is in the specification.
4. FRONT DIFFERENTIAL OIL LEVEL
Make sure the front differential oil level is in the specification.
5. OPERATION OF SHIFT SELECT LEVER
Make sure there is no abnormal noise, dragging or contact pattern in each select lever range.
WARNING: Stop the engine while checking operation of the selector lever.
C: PREPARATION TOOL
1. SPECIAL TOOLS
2. GENERAL PURPOSE TOOLS