Antilock Brakes / Traction Control Systems: Service and Repair

REMOVAL
1. Remove screws and clip from instrument panel lower cover.





2. Remove front cover (A) while disconnecting connector.
3. Remove two screws (B) and then remove center panel (C) while disconnecting connector.





4. Remove fitting screws, and slightly pull radio and switch assembly out from center console.
5. Disconnect electric connectors and antenna feeder cord and then disconnect heater control unit.





6. Remove screw and detach the bracket and then remove switch Panel.





7. Remove VDC off switch by pushing it outward.

INSTALLATION
Install is in the reverse order of removal.

INSPECTION





Check continuity between VDC off switch terminals.





If NG, replace VDC off switch.