Removal and Installation

Combination Meter Assembly

REMOVAL

1. Disconnect ground cable from battery.
2. Set tilt steering at the lowest position.
3. Disconnect each electrical connector to remove front cover (A) and switch panel (B).
4. Loosen screws (C) to remove center panel (D).




5. Remove meter visor (E).
6. Remove screws of combination meter to pull out the meter toward you.




7. Remove connector in the upper area of combination meter to remove meter.

CAUTION:
- Be careful not to damage meter or instrument panel.
- Pay particular attention to avoid damaging the meter glass.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- Make sure that electrical connector is connected securely.
- Make sure that each meter operates normally.