Flywheel: Service and Repair

Flywheel

REMOVAL
1. Remove the transmission assembly.
2. Remove the clutch cover and clutch disc.





3. Using the ST, remove the flywheel.
ST 498497100 CRANKSHAFT STOPPER

INSTALLATION





1. Install the flywheel and ST.
ST 498497100 CRANKSHAFT STOPPER
2. Tighten the flywheel attaching bolts to the specified torque.





NOTE: Tighten the flywheel installing bolts gradually. Each bolt should be tightened to the specified torque in a crisscross fashion.

Tightening torque: 72 Nm (7.3 kgf-m, 52.8 ft. lbs.)
3. Install the clutch disc and cover.
4. Install the transmission assembly.

INSPECTION

CAUTION: Since this bearing is grease sealed and is of a non-lubrication type, do not wash with gasoline or any solvent.





1. Damage of facing and ring gear If defective, replace the flywheel.
2. Smoothness of rotation
Rotate the ball bearing applying pressure in thrust direction.
3. If noise or excessive play is noted, replace the flywheel.