Rear Door: Service and Repair

REAR DOOR PANEL

Rear Door Panel:

REMOVAL

1. Disconnect the ground cable from battery.
2. Remove the rear door trim.
3. Remove the rear sealing cover.
4. Remove the rear door glass.
5. Remove the rear door regulator and motor assembly.
6. Remove the rear door latch assembly.
7. Remove the rear outer handle.
8. Remove the center pillar lower trim.
9. Remove the seatbelt bracket and blind plug.
Disconnect the connector of door harness and remove the door hinge nut.

10. Put a wooden block on the jack and place the jack under the door. Support the door with the jack to protect it.

11. Remove the checker bolts.

12. Remove the door-side bolts for upper and lower hinges to remove the door.

13. Using the ST, remove the body-side bolts for upper and lower hinges, and remove door hinges.

INSTALLATION

1. Install in the reverse order of removal.
2. Apply grease to the sliding area of door hinges.