2 - 4 Brake
2-4 BrakeREMOVAL
1. Remove the transmission assembly from the vehicle.
2. Extract the torque converter clutch assembly.
3. Remove the input shaft.
4. Disconnect the air breather hose.
5. Lift-up lever behind the transmission harness connector and disconnect it from stay.
6. Disconnect inhibitor switch connector from stay.
7. Remove the oil charger pipe.
8. Remove the oil cooler inlet and outlet pipes with washers.
9. Remove rear vehicle speed sensor, and separate the transmission case and extension case.
10. Remove reduction driven gear.
11. Separation of torque converter clutch case and transmission case.
12. Remove the oil pan and control valve body.
13. Remove the oil pump housing.
14. Remove 2-4 brake seal.
15. Take out the high clutch and reverse clutch assembly.
16. Take out the thrust needle bearing, planetary gear assembly and the low clutch assembly.
17. Remove snap ring.
18. Take out 2-4 brake return spring.
19. Remove the 2-4 brake piston and piston retainer without damaging.
20. Separate 2-4 brake piston and piston retainer.
INSTALLATION
1. Install 2-4 brake piston to 2-4 brake piston retainer.
2. Install the 2-4 brake piston and 2-4 brake retainer by aligning hole of 2-4 brake retainer and hole of transmission case.
3. Install 2-4 brake piston return spring to transmission case.
4. Position snap ring in transmission. Using ST, press the snap ring into place.
ST 498677100 COMPRESSOR
5. Install planetary gear and low clutch assembly to transmission case.
Install carefully while rotating the low clutch and planetary gear assembly slowly paying special attention not to damage the seal ring.
6. Install pressure plate, drive plate, driven plate, retaining plate and snap ring.
7. Install a new 2-4 brake oil seal to transmission case.
8. After all 2-4 brake component parts have been installed, blow in air intermittently and confirm the operation of the brake.
9. Check the clearance between the retaining plate and the snap ring.
10. Be careful not to mistake the location of the leaf spring to be inserted.
11. Install thrust needle bearing in the correct direction.
12. Install front sun gear.
13. Install thrust needle bearing in the correct direction.
14. Install the high clutch assembly.
15. Install oil pump housing to transmission case.
16. Install the control valve body and oil pan.
17. Install the torque converter clutch case assembly to the transmission case assembly.
18. Insert inhibitor switch and transmission connector into stay.
19. Install air breather hose.
20. Install the oil cooler pipes.
21. Install the oil charger pipe with O-ring.
22. Insert the input shaft while turning lightly by hand.
Normal protrusion A: 50 - 55 mm (1.7 - 2.17 inch)
23. Install the torque converter clutch assembly.
24. Install the transmission assembly to the vehicle.
INSPECTION
^ Drive plate facing for wear and damage
^ Snap ring for wear and spring retainer for deformation
^ Lip seal and lathe cut seal ring for damage
^ Measure the total end play and adjust to within specifications.
1. Inspect the clearance between the retaining plate and the snap ring.
NOTE: Select a retaining plate with a suitable value from the following table, so that the clearance becomes the standard value.
Standard value: 0.8 - 1.2 mm (0.031 - 0.047 inch)
Allowable limit: 1.5 mm (0.059 inch)