Rear Axle Disassembly

DISASSEMBLY





1. Using the ST1 and ST2, remove the hub from rear housing.
ST1 927080000 HUB STAND
ST2 927420000 HUB REMOVER
2. Remove the back plate from rear housing.
3. Using a standard screwdriver, remove the outer and inner oil seals.
4. Using a flat tip screwdriver, remove the snap ring.





NOTE: Be careful not to damage the housing at removal.

5. Using the ST1 and ST2, remove the bearing by pressing inner race.
ST1 927430000 HOUSING STAND
ST2 927440000 BEARING REMOVER





6. Remove the tone wheel bolts, and then remove the tone wheel from hub (only vehicle equipped with ABS).





7. Using the ST, press the hub bolt out.
ST 927080000 HUB STAND

CAUTION: Be careful not to hammer the hub bolts. This may deform the hub.