Removal and Replacement
FRONT BUMPERFront Bumper:
REMOVAL
CAUTION:
- Handle the bumper carefully to avoid damage to the bumper face.
- Do not damage the body during removal or installation of bumper.
- To avoid damage to the bumper, lay the removed bumper on sheet spread on the floor. Do not lay it directly on the floor.
1. Disconnect the ground terminal from battery.
2. Remove the front grille.
3. Loosen the three clips to remove the head light side cover.
4. Remove the head light assembly.
5. Pull off the front side of front mud guard to remove the clip.
6. Remove clips, and pull out bumper slightly.
7. Disconnect the fog light connector to remove the bumper.
8. Remove the E/A FORM from bumper beam.
CAUTION: E/A FORM may easily break. Do not apply excessive force to it during removal.
9. Remove the bumper beam.
INSTALLATION
CAUTION:
- Handle the bumper carefully to avoid damage to the bumper face.
- Do not damage the body during removal or installation of bumper.
1. Install in the reverse order of removal.
2. Fit the slider (A) to guide plate (B) securely.
Tightening torque:
Refer to COMPONENT of General Description for tightening torque.