Without Subaru Select Monitor

Read Diagnostic Trouble Codes (DTC)
OPERATION
WITHOUT SUBARU SELECT MONITOR








1) Take out the diagnosis connector from side of driver's seat.
2) Turn ignition switch to OFF.
3) Connect the diagnosis terminal to diagnosis connector terminal 6.
4) Turn ignition switch to ON.
5) ABS warning light is set in the diagnostic mode and blinks to identify DTC.
6) After the start code (11) is shown, the DTCs will be shown in order of the last information first. These repeat for a maximum of 3 minutes.

NOTE:
^ When there are no DTCs in memory, only the start code (11) is shown.
^ When on-board diagnosis of the ABS control module detects a problem, the information (up to a maximum of three) will be stored in EEP ROM as a DTC. When there are more than three, the most recent three will be stored. (Stored codes will stay in memory until they are cleared.)

Inspection Mode
OPERATION
Reproduce the condition under which the problem has occurred as much as possible. Drive the vehicle at a speed more than 40 km/h (25 MPH) for at least 1 minute.