Operation CHARM: Car repair manuals for everyone.

Oil Filter: Service and Repair

Engine Oil Filter

REMOVAL
1) Remove the under cover.








2) Remove the oil filter with ST.
ST 498547000 OIL FILTER WRENCH

INSTALLATION
1) Use a new oil filter and apply a thin coat of engine oil to the seal rubber.
2) Install the oil filter by turning it by hand, being careful not to damage seal rubber.
3) Tighten more (approximately 2/3 to 3/4 turn) after the seal rubber contacts the cylinder block. Do not tighten excessively, or oil may leak.

INSPECTION
1) After installing the oil filter, run the engine and make sure that no oil is leaking around seal rubber.

NOTE: The filter element and filter case are permanently jointed; therefore, interior cleaning is not necessary.

2) Check the engine oil level.