Brake Fluid: Service and Repair
Brake FluidINSPECTION
1) Check that the brake fluid level remains between "MIN" and "MAX". If out of the specified range, refill or drain fluid. If fluid level becomes close to "MIN", refill fluid.
2) Check the fluid for discoloration. If fluid color has excessively changed, drain the fluid and refill with new fluid.
REPLACEMENT
CAUTION:
^ To always maintain the brake fluid characteristics, replace the brake fluid according to maintenance schedule or earlier than that when used in severe condition.
^ The FMVSS No. 116, fresh DOT3 or 4 brake fluid must be used.
^ Cover the bleeder with waste cloth, when loosening it, to prevent brake fluid from being splashed over surrounding parts.
^ Avoid mixing different brands of brake fluid to prevent degrading the quality of the fluid.
^ Be careful not to allow dirt or dust to get into the reservoir tank.
NOTE:
^ During bleeding operation, keep the brake reservoir tank filled with brake fluid to eliminate entry of air.
^ Brake pedal operating must be very slow.
^ For convenience and safety, two people should do the work.
^ The amount of brake fluid required is approximately 500 m liters (16.9 US fl ounces 17.6 Imp fl ounces) for total brake system.
1) Either jack-up the vehicle and place a safety stand under it, or lift up the vehicle.
2) Remove both front and rear wheels.
3) Draw out the brake fluid from master cylinder with syringe.
4) Refill the reservoir tank with recommended brake fluid.
Recommended brake fluid: FMVSS No. 116, fresh DOT3 or 4 brake fluid
5) Install one end of a vinyl tube onto the air bleeder and insert the other end of the tube into a container to collect the brake fluid.
CAUTION: Brake fluid replacement sequence; (A) Front right -> (B) Rear left -> (C) Front left -> (D) Rear right
6) Instruct your co-worker to depress the brake pedal slowly two or three times and then hold it depressed.
7) Loosen the bleeder screw approximately 1/4 turn until a small amount of brake fluid drains into the container, and then quickly tighten the screw.
8) Repeat steps 6) and 7) above until there are no air bubbles in drained brake fluid and new fluid flows through vinyl tube.
NOTE: Add brake fluid as necessary while performing the air bleed operation, in order to prevent the tank from running short of brake fluid.
9) After completing the bleeding operation, hold the brake pedal depressed and tighten the screw and install bleeder cap.
Tightening torque (Bleeder screw): except 17 inch type: 8 Nm (0.8 kgf-m, 5.8 ft. lbs.) 17 inch type: 20 Nm (2.0 kgf-m, 14.5 ft. lbs.)
10) Bleed air from each wheel cylinder using the same procedures as described in steps 6) through 7) above.
11) Depress the brake pedal with a force of approximately 294 N (30 kgf, 66 lbs.) and hold it there for approximately 20 seconds. At this time check the pedal to see if it shows any unusual movement.
Visually inspect the bleeder screws and brake pipe joints to make sure that there is no fluid leakage.
12) Install the wheels, and drive vehicle for a short distance between 2 to 3 km (1 to 2 miles) to make sure that brakes are operating properly.