Throttle Cable/Linkage: Service and Repair

Accelerator Control Cable

REMOVAL
1. Remove the accelerator pedal.




2. Separate the accelerator cable and accelerator pedal.

INSTALLATION
1. Install in the reverse order of removal.

NOTE:
- If the cable clamp is damaged, replace it with a new one.
- Never fail to cover the outer cable end with boot.
- Be careful not to kink the accelerator cable.
- Do not apply grease to the throttle cable on engine side.
- Grease should not be applied to places other than specified.

2. Apply grease to the throttle cable end at the engine side.

Grease:
Parts No. 004404002
Slicolube G-30M

3. Install the pedal and then adjust it.