Tilt Steering Column

Tilt Steering Column

TILT MECHANISM





^ The steering wheel vertical position can be adjusted within a 50 mm (1.97 inch) range by using the tilt lever to unlock the steering column and lock it again at the desired position.

ENERGY-ABSORBING MECHANISM
^ For impact absorbing, a resin mold profiled fitting absorbing system is used. With this method, energy is absorbed through the press-fit load of the jacket, the sliding resistance of the distance bracket, and the shearing load of the resin mold .





^ Another measure to alleviate impact on the driver in the event of a collision is the wire which is located between the tilt pin and the distance bracket attached to the steering support beam. When a large impact load is applied to the steering column, the wire is deformed progressively. The impact energy is absorbed during this process.

STEERING SUPPORT BEAM





The steering column is held in position by a support beam which is installed crosswise in the vehicle body at a level close to the steering wheel to reduce the overhang distance of the steering wheel from the supporting point of the column. The steering shaft upper bearing is also located close to the steering wheel to increase supporting efficiency as well as to minimize vibration of the steering wheel.