Seals and Gaskets: Service and Repair
Extension Case Oil SealINSPECTION
Make sure ATF does not leak from the joint of transmission and propeller shaft. If a leak occurs, replace the oil seal.
REPLACEMENT
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Lift up the vehicle.
4) Clean the transmission exterior.
5) Drain the ATF completely.
NOTE: Tighten the ATF drain plug after draining the ATF.
Tightening torque: 25 Nm (25 kgf-m, 18.1 ft. lbs.)
6) Remove the rear exhaust pipe and muffler.
7) Remove the heat shield cover. (if equipped)
8) Remove the propeller shaft.
9) Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
10) Using the ST, install the oil seal.
ST 498057300 INSTALLER
11) Install the propeller shaft.
12) Install the heat shield cover. (if equipped)
13) Install the rear exhaust pipe and muffler.
14) Pour ATF and check the ATF level.