Transmission Temperature Sensor/Switch: Service and Repair
Shift Solenoids, Duty Solenoids and ATF Temperature SensorREMOVAL
SHIFT SOLENOIDS AND DUTY SOLENOIDS
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Lift up the vehicle.
4) Clean the transmission exterior.
5) Drain the ATF completely.
NOTE: Tighten the ATF drain plug after draining the ATF.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
6) Remove the oil pan.
7) Disconnect each solenoid connectors. Remove the connectors from clip and disconnect the connectors.
8) Remove the solenoids and duty solenoids.
ATF TEMPERATURE SENSOR
When removing the ATF temperature sensor, refer to Front Vehicle Speed Sensor.
INSTALLATION
SHIFT SOLENOIDS AND DUTY SOLENOIDS
1) Install the solenoids and duty solenoids to specified positions.
2) Tighten bolts.
Tightening torque: 8 Nm (0.8 kgf-m, 5.8 ft. lbs.)
3) Connect the harness connectors. Connect the connectors of same color, and secure the connectors to valve body using clips.
4) Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket: Three Bond 1217B (Part No. K0877YA020)
5) Apply a plenty amount of liquid gasket to three holes other than screw holes on transmission case.
Liquid gasket: Three Bond 1217B (Part No. K0877YA020)
6) Install the oil pan.
Tightening torque: 5 Nm (0.50 kgf-m, 3.6 ft. lbs.)
7) Fill ATF up to the middle of the "COLD" side on level gauge by using the gauge hole.
8) Check the ATF level.
ATF TEMPERATURE SENSOR
When installing the ATF temperature sensor, refer to Front Vehicle Speed Sensor.