With Subaru Select Monitor
Subaru Select MonitorOPERATION
READ DIAGNOSTIC TROUBLE CODE (DTC)
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to Subaru Select Monitor.
3) Insert the cartridge into Subaru Select Monitor.
4) Connect the Subaru Select Monitor to data link connector.
1) Data link connector located in the lower portion of instrument panel (on the driver's side).
2) Connect the diagnosis cable to data link connector.
CAUTION: Do not connect scan tools other than the Subaru Select Monitor or an OBD-II general scan tool.
5) Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
6) On the <
7) On the
8) Press the [YES] key after engine type information is displayed.
9) On the <
10) On the
NOTE:
^ For detailed operation procedures, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
^ For details concerning diagnostic trouble codes (DTCs), refer to the List of Diagnostic Trouble Codes (DTC).
^ A maximum of 3 DTCs are displayed in order of occurrence.
^ If a particular DTC is not properly stored in memory (due to a drop in ABSCM & H/U power supply, etc.) when a problem occurs, the DTC, followed by a question mark "?" appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.
READ CURRENT DATA
1) On the
2) On the <
3) Press the [YES] key after the ABS type information is displayed.
4) On the <
5) On the display screen, select (Data Display) and press the [YES] key.
6) Using the scroll key, move the display screen up or down until desired data is shown.
^ A list of the support data is shown in the following table.
NOTE: For detailed operation procedures, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
CLEAR MEMORY MODE
1) On the
2) On the <
3) Press the [YES] key after engine type information is displayed.
4) On the <
5) When "Done" and "turn ignition switch to OFF" are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
NOTE: For detailed operation procedures, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
ABS SEQUENCE CONTROL
FREEZE FRAME DATA
NOTE:
^ Data stored at the time of trouble occurrence is shown on display.
^ Each time a trouble occurs, the latest information is stored in the freeze frame data in memory.
^ Up to three freeze frame data will be stored.
^ If a freeze frame data is not properly stored in memory (due to a drop in ABSCM power supply, etc.), a DTC preceded by a question mark "?" appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.
ANALOG DATA DISPLAY
ON/OFF DATA DISPLAY