With Manufacturer's Scan Tool

SUBARU SELECT MONITOR (NORMAL MODE)

1. On the [[Main Menu]] display screen, select {2. Each System Check} and press the [YES] key.
2. On the [[System Selection Menu]] display screen, select {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the engine type information is displayed.
4. On the [[Engine Diagnosis]] display screen, select {Clear Memory} and press the [YES] key.
5. When [[Done]] and [[Turn Ignition Switch OFF]] are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.

NOTE:
- For detailed operation procedures, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.

SUBARU SELECT MONITOR (OBD MODE)

1. On the [[Main Menu]] display screen, select {2. Each System Check) and press the [YES] key.
2. On the [[System Selection Menu]] display screen, select {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the engine type information is displayed.
4. On the [[Engine Diagnosis]] display screen, select {OBD System} and press the [YES] key.
5. On the [[OBD Menu>. display screen, select {4. Diagnosis Code(s) Cleared} and press the [YES] key.
6. When [[Clear Diagnostic Code?]] is shown on the display screen, press the [YES] key.
7. Turn the Subaru Select Monitor and ignition switch to OFF.

NOTE:
- For detailed operation procedures, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.