Rear Axle Disassembly

DISASSEMBLY





1) Using ST1 and ST2, remove the hub from the rear housing.
ST 927080000 HUB STAND
ST 927420000 HUB REMOVER
2) Remove the back plate from the rear housing
3) Using a standard screwdriver, remove the outer and inner oil seals.

CAUTION: Use new oil seals.





4) Using flat bladed screwdriver, remove the snap ring.

CAUTION: Be careful not to damage housing at removal.





5) Using ST1 and ST2, remove the bearing by pressing inner race.
ST1 927430000 HOUSING STAND
ST2 927440000 BEARING REMOVER

CAUTION:
^ If the hub was removed, replace the bearing with a new one.
^ Do not re-use bearing after removal.

6) Remove the tone wheel bolts and remove the tone wheel from the hub.





7) Using ST, press the hub bolt out.
ST 927080000 HUB STAND

CAUTION: Be careful not to hammer the hub bolts. This may deform hub.