Keyless Entry Transmitter: Testing and Inspection

Keyless Transmitter

REPLACEMENT

TRANSMITTER REGISTRATION

NOTE:
- A maximum of four transmitters can be registered for each individual vehicle.
- When replacing or adding the transmitter (key), registration is also necessary.
- Finish the operation from step (1) through (4) within 45 seconds.

1. Sit on the driver's seat and close all doors and rear gate.
2. Open the driver's door.
3. Close the driver's door.
4. Turn the ignition switch from ON to LOCK ten times within 15 seconds.

NOTE: Do not start the engine at this time.

5. The horn chirps one time to indicate that the system has entered in the programming mode.
6. Open the driver's door.
7. Close the driver's door.
8. Press any button on the transmitter that you wish to program into the system.
9. Horn will chirp two times to indicate that the transmitter has been programmed.

NOTE: Repeat steps (6) through (9) for an additional transmitter.

10. Remove the ignition key from the ignition switch.
11. The horn will chirp three times to indicate that the system has exited the programming mode.
12. Check the keyless entry system properly operates by operating each transmitter.