Oil Filter: Service and Repair

Engine Oil Filter

REMOVAL





1. Remove access lid.





2. Remove oil filter with ST.
ST 498547000 OIL FILTER WRENCH

INSTALLATION
1. Get a new oil filter and thinly apply engine oil to the seal rubber.
2. Install oil filter by turning it by hand, being careful not to damage seal rubber.
3. Tighten more (approximately 2/3 to 3/4 turn) after the seal rubber contacts the oil pump case. Do not tighten excessively, or oil may leak.

INSPECTION
1. After installing oil filter, run engine and make sure that no oil is leaking around seal rubber.

NOTE: The filter element and filter case are integrated therefore, interior cleaning is not necessary.

2. Check the engine oil level.