Link Front

Link Front

REMOVAL
1. Loosen wheel nuts. Lift-up vehicle and remove wheel.







2. Use transmission jack to support rear arm horizontally.







3. Remove bolt securing link front to sub frame.







4. Remove bolts which secure link front to rear arm and detach link front.

NOTE: Link front bushing cannot be replaced alone. Always replace link front and bushing as a single unit.

INSTALLATION
Install in the reverse order of removal, observing the following instructions.







CAUTION: Using transmission jack, support rear arm horizontally, install link front and tighten nuts to specified torque.







Install link front with protruded side facing

Replace self-locking nut.

NOTE: Check wheel alignment and adjust if necessary.

Tightening torque:
120 Nm (12.2 kgf-m, 88 ft. lbs.)


INSPECTION
Visually check link front for damage or bends.