Throttle Cable/Linkage: Service and Repair

Accelerator Control Cable

REMOVAL

1. Remove accelerator pedal.
2. Separate accelerator cable and accelerator pedal

INSTALLATION

1. Install in the reverse order of removal.




2. Apply grease at the accelerator cable end on engine room side.
Part No. 004404002 (Slico lube G-30M)

NOTE:
- If cable clamp is damaged, replace it with a new one.
- Never fail to cover outer cable end with boot.
- Be careful not to kink accelerator cable.
- Do not apply grease except for special area.

3. Adjustment after pedal installation.

INSPECTION

1. Make sure the inner cable is not twisted or frayed.
2. Make sure the outer cable is not cracked.