Gear Sensor/Switch: Service and Repair
Switches and HarnessREMOVAL
1. Disconnect connector battery ground cable.
2. Remove air intake duct and cleaner case.
3. Disconnect connector back-up light switch and neutral position switch.
4. Lift-up the vehicle.
5. Remove back-up light switch and neutral position switch with harness.
INSTALLATION
BACK-UP LIGHT SWITCH AND NEUTRAL POSITION SWITCH
1. Install back-up light switch and neutral position switch with harness.
Tightening torque: 24.5 Nm (2.5 kgf-m, 18.1 ft. lbs.)
2. Connect connector of back-up light switch and neutral position switch.
3. Install air intake duct and cleaner case.
4. Connect battery ground cable.