Speedometer Gear
Speedometer GearREMOVAL
1. Remove the manual transmission assembly from vehicle.
2. Remove back-up light switch and neutral position switch.
3. Remove transfer case with extension case assembly.
4. Remove transmission case.
5. Remove vehicle speed sensor.
6. Remove outer snap ring and pull out speedometer driven gear. Next, remove oil seal, speedometer shaft and washer.
INSTALLATION
1. Install washer and speedometer shaft, and press fit new oil seal with ST.
ST 899824100 or 499827000PRESS
2. Install vehicle speed sensor.
3. Install speedometer driven gear and new snap ring.
4. Install transmission case.
5. Install transfer case with extension case assembly.
6. Install back-up light switch and neutral position switch.
7. Install the manual transmission assembly to vehicle.
INSPECTION
Check the speedometer gear, oil seal and speedometer shaft for damage. Replace if damaged.