Rear Door: Service and Repair

REAR DOOR PANEL

Rear Door Panel:

REMOVAL

1. Disconnect ground cable from battery.
2. Remove rear door trim.
3. Remove rear door regulator and motor assembly.
4. Remove rear door latch.
5. Remove rear outer handle.
6. Remove center pillar lower trim.
7. Remove seatbelt bracket and blind plug. Disconnect connector of door harness and remove door hinge nut.

8. Put a wooden block on the jack and place the jack under the door. Support the door with the jack to protect it.
9. Remove checker bolts.

10. Remove door-side bolts for upper and lower hinges to remove door.

11. Using special tool, remove body-side bolts for upper and lower hinges, and remove door hinges.

ST 925610000 WRENCH

CAUTION:
- During removal and installation of doors, do not damage body.
- Doors are heavy. Be careful not to drop and damage them.

INSTALLATION

1. Install in the reverse order of removal.
2. Apply grease to sliding area of door hinges.

Tightening torque: Refer to COMPONENT in General Description.