Condenser HVAC: Service and Repair

REMOVAL

1. Using refrigerant recovery system, discharge refrigerant.
2. Disconnect ground cable from battery.




3. Remove duct (A).




4. Disconnect high-pressure hose (A) and low-pressure hose (B) from condenser.




5. Remove radiator bracket (A).




6. Remove 2 bolts. While lifting condenser, pull it out through the space between the radiator and the radiator panel.

CAUTION:
Be careful not to damage condenser fins. If a damaged fin is found, repair it using a thin screwdriver.

If condenser is replaced, add appropriate amount of compressor oil to the compressor.

INSTALLATION

1. Install in the reverse order of removal.

CAUTION: Replace O-rings on hoses or pipes with new ones, and then apply compressor oil. Confirm that lower guide of condenser has been fitted into holes on radiator panel.

2. Charge refrigerant.