Rear Drive Shaft
Rear Drive ShaftREMOVAL
1. Remove transmission assembly.
2. Remove rear wheel speed sensor and separate extension case from transmission case.
3. Pull out the rear driveshaft from the center differential assembly.
4. Remove drive plate and driven plate.
INSTALLATION
1. Select the appropriate shim.
2. Install drive plate and driven plate.
3. Insert rear driveshaft into the center differential assembly.
4. Join transmission case and extension case. Install rear wheel speed sensor.
5. Install transmission assembly.
DISASSEMBLY
1. Using a press, remove revolution gear.
2. Using a press, remove the front and rear side ball bearings and clutch hub.
ASSEMBLY
Assemble in the reverse order of disassembly.
NOTE:
^ Use a new revolution gear and ball bearings.
^ Make sure the clutch hub is oriented in the correct direction.
INSPECTION
^ Inspect parts to make sure there are no holes, cuts, and that they are not dusty.
^ Inspect extension end play and adjust it to within the standard value.