Front Axle Assembly

ASSEMBLY





1. Attach hub to ST securely.
ST 927080000 HUB STAND
2. Using a hydraulic press, press new hub bolts into place.

CAUTION: Be sure to press hub bolts until their seating surfaces contact the hub.

NOTE: Use 12 mm (0.47 inch) dia. holes in HUB STAND to prevent bolts from tilting.

3. Clean dust or foreign particles from inside the housing.
4. Using ST1 and ST2, press a new bearing into place.
ST1 927400000 HOUSING STAND
ST2 927100000 BEARING REMOVER





CAUTION:
^ Always press outer race when installing bearing.
^ Be careful not to remove plastic lock from inner race when installing bearing.
^ Charge bearing with new grease when outer race is not removed.

Specified grease: SHELL 6459N





5. Using pliers, install snap ring in its groove.

CAUTION: Make sure to install it firmly to groove.





6. Using ST1 and ST2, press inner oil seal until it contacts circlip.
ST1 927410000 OIL SEAL INSTALLER
ST2 927400000 HOUSING STAND
7. Invert ST and housing.
ST 927400000 HOUSING STAND





8. Using ST1 and ST2, press outer oil seal until it contacts the bottom of housing.
ST1 927410000 OIL SEAL INSTALLER
ST2 927400000 HOUSING STAND
9. Apply sufficient grease to oil seal lip.
Specified grease SHELL 6459N

CAUTION:
^ If specified grease is not available, remove bearing grease and apply Auto Rex A instead.
^ Do not mix different types of grease.

10. Install disc cover to housing the three bolts.
Tightening torque: 18 Nm (1.8 kgf-m, 13.0 ft. lbs.)
11. Attach hub to ST1 securely.
12. Clean dust or foreign particles from the polished surface of hub.





13. Using ST2, press bearing into hub by driving inner race.
ST1 927080000 HUB STAND
ST2 927120000HUB INSTALLER