Rear Wiper Motor

Rear Wiper Motor

REMOVAL

1. Disconnect the ground cable from battery.
2. Remove the rear wiper arm.




3. Remove the cap (A), nut (B), and spacer (C) from rear wiper shaft.
4. Remove the rear gate lower trim.
5. Unclip the clip of harness and disconnect the connector of wiper motor.




6. Loosen the bolts to remove the wiper motor assembly (A).

INSTALLATION

1. Install in the reverse order of removal.




2. Install the rear wiper cushion with the arrow mark facing up, as shown in the figure.