Transmission Speed Sensor: Service and Repair

REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the intercooler.





3. Disconnect the vehicle speed sensor connector.
4. Remove the vehicle speed sensor.

INSTALLATION





1. Align the tip end of vehicle speed sensor key with key groove on the end of speedometer shaft, and then install it.
Tightening torque: 5.9 Nm (0.6 kgf-cm, 4.4 ft. lbs.)

NOTE:
^ Ensure the sensor mounting hole is clean and free of foreign matter.
^ Discard the vehicle speed sensor after removal, and replace it with a new one.

2. Connect the connector to vehicle speed sensor.
3. Install the intercooler.