Body and Electrical
REAR BUMPERRear Bumper (Sedan):
Rear Bumper (Wagon):
REMOVAL
1. SEDAN
CAUTION:
- Handle bumper carefully to avoid damage to bumper face.
- Do not damage body during removal or installation of bumper.
- To avoid damage to bumper, lay removed bumper on sheet spread on the floor. Do not lay it directly on the floor.
1. Lift-up the vehicle.
2. Remove bolts and clips.
3. Loosen clips to remove trunk rear trim.
4. Remove hook (A) to pull off rear side of trunk side trim.
5. Remove two nuts from each side to remove rear bumper.
6. Loosen clips to remove upper beam (A) from bumper face.
7. Remove resin beam.
2. WAGON
CAUTION:
- Handle bumper carefully to avoid damage to bumper face.
- Do not damage body during removal or installation of bumper.
- To avoid damage to bumper, lay removed bumper on sheet spread on the floor. Do not lay it directly on the floor.
1. Lift-up the vehicle.
2. Remove trailer hitch.
3. Remove bolts and clips.
4. Remove rear floor box.
5. Pull off rear end of rear quarter lower trim to remove cap.
6. Loosen bolts to remove rear bumper.
7. Loosen clip (A) to remove bumper beam (B) from rear bumper face (C).
8. Remove resin beam from bumper beam.
INSTALLATION
1. SEDAN
CAUTION:
- Handle bumper carefully to avoid damage to bumper face.
- Do not damage body during removal or installation of bumper.
1. Install in the reverse order of removal.
2. Fit slider (A) to guide pin (B) securely.
Tightening torque: Refer to COMPONENT in General Description.
2. WAGON
CAUTION:
- Handle bumper carefully to avoid damage to bumper face.
- Do not damage body during removal or installation of bumper.
1. Install in the reverse order of removal.
2. Fit slider (A) to guide pin (B) securely.
Tightening torque: Refer to COMPONENT in General Description.