U5/Low Emissions Models
Clear Memory ModeOPERATION
SUBARU SELECT MONITOR (NORMAL MODE)
1. On Main Menu display screen, select the {2. Each System Check} and press the [YES] key.
2. On System Selection Menu display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type is displayed.
4. On Engine Diagnosis display screen, select the {Clear Memory} and press the [YES] key.
5. When the 'Done' and Turn Ignition Switch OFF' are shown on display screen, turn the ignition switch to OFF, and then turn the Subaru Select Monitor to OFF.
NOTE:
- After the memory has been cleared, the idle air control solenoid valve must be initialized. To do this, turn the ignition switch to ON position. Wait 3 seconds before starting the engine.
- For detailed operation procedure, refer to SUBARU SELECT MONITOR OPERATION MANUAL.
SUBARU SELECT MONITOR (OBD MODE)
1. On Main Menu display screen, select the {2. Each System Check} and press the [YES] key.
2. On System Selection Menu display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type is displayed.
4. On Engine Diagnosis display screen, select the {OBD System} and press the [YES] key.
5. On OBD Menu display screen, select the {4. Diagnosis Code(s) Cleared} and press the [YES] key.
6. When the 'Clear Diagnostic Code?' is shown on the display screen, press the [YES] key.
7. Turn the Subaru Select Monitor and ignition switch to OFF.
NOTE:
- After the memory has been cleared, the idle air control solenoid valve must be initialized. To do this, turn the ignition switch to ON position. Wait 3 seconds before starting the engine.
- For detailed operation procedure, refer to SUBARU SELECT MONITOR OPERATION MANUAL.