Fuel Injector (U5/Low Emissions)
REMOVALRH SIDE
1. Release fuel pressure.
2. Open fuel flap lid, and remove fuel filler cap.
3. Disconnect battery ground cable.
4. Remove air cleaner case.
5. Remove spark plug cords from spark plugs (#1 and #3 cylinders).
6. Remove power steering pump and tank from brackets.
1. Remove front V-belt.
2. Remove bolts which hold power steering pipes onto intake manifold protector.
3. Remove bolts which install power steering pump to bracket.
4. Disconnect connector from power steering pump switch.
5. Remove power steering tank from the bracket by pulling it upwards.
6. Place power steering pump and tank on the right side wheel apron.
7. Remove fuel pipe protector RH.
8. Disconnect connector (A) from fuel injector.
9. Remove harness band (B) which holds engine harness onto injector pipe.
10. Remove bolts which hold injector pipe to intake manifold.
11. Lift up fuel injector pipe, and remove fuel injector.
LH SIDE
1. Release fuel pressure.
2. Open fuel flap lid, and remove fuel filler cap.
3. Disconnect battery ground cable.
4. Remove two bolts which install washer tank on body.
5. Disconnect connector from front window washer motor.
6. Disconnect connector from rear gate glass washer motor.
7. Disconnect rear window glass washer hose from washer motor, then plug connection with a suitable cap.
8. Move washer tank, and secure it away from working area.
9. Remove spark plug cords from spark plugs (#2 and #4 cylinders).
10. Remove fuel pipe protector LH.
11. Disconnect connector (A) from fuel injector.
12. Remove harness band (B) which holds engine harness onto injector pipe.
13. Remove bolt which holds injector pipe to intake manifold.
14. Lift up fuel injector pipe, and remove fuel injector.
INSTALLATION
RH SIDE
Install in the reverse order of removal.
NOTE: Replace O-rings with new ones.
LH SIDE
Install in the reverse order of removal.
NOTE: Replace O-rings with new ones.