With Subaru Select Monitor
Subaru Select MonitorOPERATION
READ DIAGNOSTIC TROUBLE CODE (DTC)
1. Prepare Subaru Select Monitor kit.
2. Connect diagnosis cable to Subaru Select Monitor.
3. Insert cartridge into Subaru Select Monitor.
4. Connect Subaru Select Monitor to data link connector.
1 Data link connector located in the lower portion of the instrument panel (on the driver's side).
2 Connect diagnosis cable to data link connector.
5. Turn ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
6. On the [[Main Menu,, display screen, select the {Each System Check} and press the [YES] key.
7. On the [[System Selection Menu]] display screen, select the {Brake Control System} and press the [YES] key.
8. Press the [YES] key after displayed the information of ABS type.
9. On the [[ABS Diagnosis]] display screen, select the {Diagnostic Code(s) Display} and press the [YES] key.
10. On the [[Diagnostic Code(s) Display,, display screen, select the {Current Diagnostic Code(s)} or {History Diagnostic Code(s)} and press the [YES] key.
NOTE:
^ For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
^ For detailed concerning diagnostic trouble codes, refer to the LIST OF DIAGNOSTICS TROUBLE CODE.
^ A maximum of 3 DTC are displayed in order of occurrence.
^ If a particular DTC is not properly stored in memory (due to a drop in ABSCM&H/U power supply, etc.) when a problem occurs, the DTC, followed by a question mark "?", appears on the select monitor display. This shows it may be an unreliable reading.
READ CURRENT DATA
1. On the [[Main Menu,, display screen, select the {Each System Check} and press the [[YES]] key.
2. On the [[System Selection Menu,, display screen, select the {Brake Control System} and press the [[YES]] key.
3. Press the [[YES]] key after displayed the information of ABS type.
4. On the [[Brake Control Diagnosis,, display screen, select the {Current Data Display & Save} and press the [[YES,, key.
5. On the [[Data Display Menu,, display screen, select the {Data Display} and press the [[YES]] key.
6. Using the scroll key, move the display screen up or down until the desired data is shown.
^ A list of the support data is shown in the following table.
NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
CLEAR MEMORY MODE
1. On the [[Main Menu,, display screen, select the {2. Each System Check} and press the [[YES]] key.
2. On the [[System Select Menu]] display screen, select {Brake System} and press the [[YES]] key.
3. Press the [[YES]] key after displayed the information of ABS type.
4. On the [[Brake Control Diagnosis]] display screen, select the {Clear Memory} and press the [[YES]] key.
5. When the "Done" and "turn ignition switch OFF" are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
ABS SEQUENCE CONTROL
FREEZE FRAME DATA
NOTE:
^ Data stored at the time of trouble occurrence is shown on display.
^ Each time trouble occurs, the latest information is stored in the freeze frame data in memory.
^ If freeze frame data is not properly stored in memory (due to a drop in ABSCM power supply, etc.), a DTC, preceded by a question mark "?", appears on the select monitor display. This shows it may be an unreliable reading.
^ In case of no trouble code, the initial value of freeze frame data will be displayed.
ANALOG DATA ARE DISPLAYED.
ON/OFF DATA ARE DISPLAYED.