V-Belt
V-beltREMOVAL
FRONT SIDE BELT
1. Remove the V-belt cover.
2. Loosen the lock bolt (A).
3. Loosen the slider bolt (B).
4. Remove the front side belt (C).
REAR SIDE BELT
1. Loosen the lock nut (A).
2. Loosen the slider bolt (B).
3. Remove the A/C belt.
4. Remove the A/C belt tensioner.
INSTALLATION
FRONT SIDE BELT
CAUTION: Wipe off any oil or water on the belt and pulley.
1. Install the belt (c), and tighten the slider bolt so as to obtain the specified belt tension.
3. Tighten the slider bolt (B).
Tightening torque:
Lock bolt through bolt: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
Slider bolt: 8 Nm (0.8 kgf-m, 5.5 ft. lbs.)
REAR SIDE BELT
1. Install the belt, and tighten the slider bolt (B) so as to obtain the specified belt tension.
2. Tighten the lock nut (A).
Tightening torque:
Lock nut (A), 22.6 Nm (2.3 kgf-m, 16.6 ft. lbs.)
INSPECTION
1. Replace the belts, if cracks, fraying or wear is found.
2. Check the drive belt tension and adjust it if necessary by changing generator installing position and/or idler pulley installing position.
Belt tension (With using belt tension gauge)
(A)
replaced: 618 - 755 N (63 - 77 kgf, 139 - 170 lbs.)
reused: 490 - 640 N (50 - 65 kgf, 110 - 144 lbs.)
(B)*
replaced: 740 - 880 N (75 - 90 kgf, 166 - 198 lbs.)
reused: 350 - 450 N (36 - 46 kgf, 78 - 101 lbs.)
*: with air conditioner
Belt tension
(A)
replaced: 7 - 9 mm (0.276 - 0.354 inch)
reused: 9 - 11 mm (0.354 - 0.433 inch)
(B)*
replaced: 7.5 - 8.5 mm (0.295 - 0.335 inch)
reused: 9.0 - 10.0 mm (0.354 - 0.394 inch)
*: with air conditioner