Rear Oxygen Sensor

Rear Oxygen Sensor

REMOVAL




1. Disconnect the ground cable from battery.
2. Lift-up the vehicle.




3. Disconnect the connector from the rear oxygen sensor.




4. Remove the clip by pulling out from the upper side of crossmember.
5. Apply SUBARU CRC or its equivalent to the threaded portion of rear oxygen sensor, and leave it for one minute or more.

SUBARU CRC (Part No. 004301003)




6. Remove the rear oxygen sensor.

CAUTION: When removing the oxygen sensor, wait until exhaust pipe cools; otherwise, it will damage exhaust pipe.

INSTALLATION
1. Before installing rear oxygen sensor, apply antiseize compound only to the threaded portion of rear oxygen sensor to make the next removal easier.

CAUTION: Never apply anti-seize compound to protector of rear oxygen sensor.

Anti-seize compound: SS-30 by JET LUBE




2. Install the rear oxygen sensor.




3. Connect the connector to the rear oxygen sensor.




4. Connect the clip to the crossmember.
5. Lower the vehicle.




6. Connect the battery ground cable to battery.