Cruise Control Command Switch

Cruise Control Command Switch

REMOVAL

WARNING: Before servicing, be sure to read the notes in the AB section for proper handling of the driver's airbag module.

1. Set front wheels in straight ahead position.
2. Turn ignition switch OFF.
3. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.




4. Using TORX(R) BIT T30 (Tamper resistant type), loosen two TORX(R) bolts which secure driver's airbag module.
5. Disconnect airbag module connector on back of airbag module.




6. Remove horn switch from steering wheel as shown.




7. Disconnect horn and cruise control command switch connector, then remove cruise control command switch.

INSTALLATION
Install is in the reverse order of removal.