Engine Control Module: Service and Repair

Engine Control Module

REMOVAL




1. Disconnect ground cable from battery.
2. Remove lower inner trim of passenger side.
3. Detach floor mat of passenger seat.




4. Remove protect cover.
5. Remove nuts (A) which hold ECM to bracket.




6. Remove clip (B) from bracket.
7. Disconnect ECM connectors and take out ECM.

INSTALLATION
Install in the reverse order of removal.

CAUTION: When replacing ECM, be careful not to use the wrong spec. ECM to avoid any damage to the fuel injection system.

Tightening torque: 5 N.m (0.51 kgf.m, 3.7 ft.lb)