Throttle Cable/Linkage: Service and Repair

Accelerator Control Cable

REMOVAL
1. Remove accelerator pedal.
2. Separate accelerator cable and accelerator pedal.

INSTALLATION
1. Install in the reverse order of removal.




2. Apply grease to the point (accelerator cable end on engine side) shown in the figure.

Part No.004404002 (Slico lube G-30M)

CAUTION:
- If cable clamp is damaged, replace it with a new one.
- Never fail to cover outer cable end with boot.
- Be careful not to kink accelerator cable.
- Do not apply grease except for special area.

3. Adjustment after pedal installation.