Real-Time Diagnosis

REAL-TIME DIAGNOSIS

1. Connect the select monitor.
2. Turn the ignition switch and cruise control main switch to ON.
3. Turn the Subaru Select Monitor switch to ON.
4. On the Main Menu display screen, select the {2. Each System Check} and press [YES] key.
5. On the System Selection display screen, select the {Engine} and press [YES] key.
6. Press the [YES] key after the information of engine type displayed.
7. On the Engine Diagnosis display screen, select the {Current Data Display & Save} and press [YES] key.
8. Make sure that normal indication is displayed when controls are operated as indicated below:
- Depress/release the brake pedal. (Stop light switch and brake switch turn ON.)
- Turn ON the SET/COAST switch.
- Turn ON the RESUME/ACCEL switch.
- Turn ON the CANCEL switch. (The SET/COAST and RESUME/ACCEL switch are turned ON at same time.)
- Depress/release the clutch pedal.
- Set the shift lever to except for neutral position.

NOTE:
- For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
- For details concerning DTCs,