Extension Case Oil Seal
INSPECTIONMake sure the ATF does not leak from the joint of transmission and propeller shaft. If so, replace the oil seal.
REPLACEMENT
1. Clean the transmission exterior.
2. Drain the ATF completely.
NOTE: Tighten the drain plug (ATF) after draining the ATF.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
3. Remove the rear exhaust pipe and muffler.
4. Remove the heat shield cover. (If equipped)
5. Remove the propeller shaft.
6. Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
7. Using the ST, install the oil seal.
ST 498057300 INSTALLER
8. Install the propeller shaft.
9. Install the heat shield cover. (If equipped)
10. Install the rear exhaust pipe and muffler.
11. Pour ATF and check the ATF level.
12. Pour ATF into the oil charge pipe.
Recommended fluid: Dexron III type automatic transmission fluid
Capacity: Fill the same amount of ATF drained.
13. Bleed the air of control valve.
14. Check the level and leaks of ATF.