Differential Side Retainer Oil Seal
Differential Side Retainer Oil SealINSPECTION
Check the leakage of gear oil from differential side retainer oil seal part. If there is oil leakage, replace the oil seal.
REPLACEMENT
1. Lift-up the vehicle.
2. Remove the front exhaust pipe and center exhaust pipe.
3. Drain the differential gear by removing differential gear oil drain plug.
4. Replace new gasket and tighten the differential oil drain plug.
Tightening torque:
70 Nm (7.1 kgf-m, 51 ft. lbs.) (Copper gasket)
44 Nm (4.5 kgf-m, 33 ft. lbs.) (Aluminum gasket)
5. Separate the front drive shaft from transmission.
6. Remove the differential side retainer oil seal using driver which wrapped with vinyl tape or etc.
7. Using ST, install the differential side retainer oil seal by slightly tapping with hammer.
ST 18675AA000 DIFFERENTIAL SIDE OIL SEAL INSTALLER
8. Apply oil to the oil seal lips.
9. Using the ST, install the front drive shaft.
ST 28399SA010 OIL SEAL PROTECTOR
10. Install the front exhaust pipe and center exhaust pipe.
11. Lower the vehicle.
12. Pour differential gear oil into the gauge hole.
Differential gear oil capacity: 1.1 - 1.30 l (1.3 - 1.4 USqt, 1.0 - 1.1 Imp qt)
13. Check the gear oil amount.