Rear Wiper Motor

Rear Wiper Motor

REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the rear wiper arm.
3. Remove the rear gate lower trim.
4. Unclip the clip of harness, and then disconnect the connector of wiper motor.




5. Loosen the bolts to remove the wiper motor assembly (A).
6. Remove rear wiper cushion.

INSTALLATION
1. Install in the reverse order of removal.




2. Install the rear wiper cushion with the arrow mark facing up, as shown in the figure.

Tightening torque:
T1: 6.0 N.m (0.61 kgf-m, 4.4 ft-lb)
T2: 8.0 N.m (0.82 kgf-m, 5.9 ft-lb)