Rear Seat

Rear Seat

REMOVAL

1. SEDAN MODEL




1. Remove the two hooks while lifting up the rear seat cushion.




2. Remove the hook (A) by pushing it backward while lifting up the front side of seat cushion to detach seat cushion.




3. Remove the lower anchor bolt of rear center seat belt.




4. Remove the bolts which secure the bottom of backrest.




5. Remove the anchor part on backrest side from the hook on body side (A) while lifting up the backrest to detach it from vehicle.

2. WAGON MODEL
1. Disconnect the ground cable from battery.




2. Remove the two hooks while lifting up the rear seat cushion.




3. Remove the hook (A) by pushing it backward while lifting up the front side of seat cushion to detach seat cushion.
4. Remove the headrest, and then tilt the backrest forward.
5. Remove the luggage floor box.




6. Remove the hinge assembly center bolts.




7. Remove the backrest from hinge assembly LH (hinge assembly RH).

NOTE: The backrest cannot be detached when the hinge assembly side does not mate with the backrest pin position.




8. Remove the lower anchor bolt (A) of outer seat belt and backrest shoulder bolt (B).




9. Remove the backrest shoulder with lifting it up.




10. Remove the belt cover (A) from backrest shoulder cover, and then pull out the seat belt.

INSTALLATION

1. SEDAN MODEL
Install in the reverse order of removal.

NOTE:
- After installing the backrest, make sure that each seat belt operates normally.
- Make sure that they are secured on each hook of vehicle side.

Tightening torque:
T1: 10 N.m (1.02 kgf-m, 7.38 ft-lb)
T2: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)

2. WAGON MODEL
Install in the reverse order of removal.

NOTE:
- After installing the backrest, make sure that each seat belt operates normally.
- Make sure that they are secured on each hook of vehicle side.

Rear Seat (Sedan Model):

Rear Seat (Wagon Model):

Tightening torque:
T1: 13.7 N.m (1.40 kgf-m, 10.1 ft-lb)
T2: 22 N.m (2.24 kgf-m, 16.2 ft-lb)
T3: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)