VDC Sequence Control

OPERATION
1. While the VDC sequence control is performed, the operation of the hydraulic unit can be checked using the brake tester or pressure gauge after the hydraulic unit solenoid valve is operated.
2. VDC sequence control can be started by Subaru Select Monitor.

VDC SEQUENCE CONTROL WITH SUBARU SELECT MONITOR

NOTE: In the event of any trouble, the sequence control may not be operative.

1. Connect the Subaru Select Monitor to data link connector under the driver's side instrument panel lower cover.
2. Turn the ignition switch to ON.
3. Set the Subaru Select Monitor switch to ON.
4. Set the Subaru Select Monitor to the "Brake Control" mode.
5. When the "VDC Inspection Mode" is selected from the "Function check sequence" menu, the "VDC sequence control" will start.
6. Since "Press the [YES] key" is displayed, press the YES key.
7. Operation points will be displayed on the Subaru Select Monitor.

CONDITIONS FOR VDC SEQUENCE CONTROL








NOTE: The control operation starts from point A.

SPECIFICATION
CONDITIONS FOR COMPLETION OF VDC SEQUENCE CONTROL
When the following conditions develop, the VDC sequence control stops and VDC operation is returned to the normal control mode.
1. When the speed of at least one wheel reaches 10 km/h (6 MPH).
2. When the brake pedal is pressed during sequence control and the stop light switch is set to ON.
3. After completion of VDC sequence control.
4. When malfunction is detected.