Airbag Connectors
Airbag ConnectorsGENERAL
The airbag system uses connectors with a double lock mechanism and an incomplete-coupling-detection mechanism for enhanced reliability. If coupling is incomplete, the airbag warning light comes on in the combination meter.
DRIVER'S SEAT AIRBAG MODULE-TO-SEAT BELT PRETENSIONER CONNECTOR
Disconnection:
1. Lift the lock button using a thin tipped tool like a miniature screwdriver.
2. Pull the connector out from the airbag module.
Connection:
Carefully insert the connector into the airbag module. Push the connector until a "click" is heard from the lock button.
AIRBAG MAIN HARNESS-TO-ROLL CONNECTOR, AND PASSENGER'S SEAR AIRBAG MODULE CONNECTOR
Disconnection:
1. Press the slide lock inwards.
2. While the slide lock pressed in, disconnect the connector (A).
Connection:
Insert the female side connector half into the other until a "click" is heard.
SIDE AIRBAG MODULE AND CURTAIN AIRBAG MODULE CONNECTORS
Disconnection:
1. Push in and hold the lock arm (A), then pull the slide lock (B).
2. While the slide lock pulled and held (B), release the lock arm (C).
3. While the slide lock pulled and held (B), disconnect the connector (D).
Connection:
Insert the female side connector half into the other until a "click" is heard.
AIRBAG HARNESS-TO-BODY HARNESS, OCCUPANT DETECTION CONTROL MODULE-TO-BODY HARNESS, AND SEAT BELT BUCKLE SWITCH CONNECTORS
Disconnection:
Hold slide lock (A) moved in the direction of the arrow, then pull the female connector in the direction of the arrow.
Connection:
Push the connector (A) into the male connector carefully until a "click" is heard.
FRONT SUB SENSOR, SIDE AIRBAG SENSOR, CURTAIN AIRBAG SENSOR, AND SEAT POSITION SENSOR (LH) CONNECTORS
Disconnection:
Holding the outer part (A), pull the connector in the direction of the arrow.
Connection:
Holding the inner part, push the connector into the socket carefully until a "click" is heard. Do not hold the outer part (A) as it moves back during connection of the connector.