Component Tests

Airbag Connector

PROCEDURE

1. BUCKLE SWITCH AND OCCUPANT DETECTION CONTROL MODULE
1. How to disconnect:
1. Move the slide lock (A) in the direction of arrow.




2. With the slide lock (A) moved, separate the connector.

CAUTION: When pulling the slide lock or disconnecting the connector, be sure to hold onto the connector and not the wire.


2. How to connect:




Holding the connector (A), and push it in carefully until a connecting sound is heard.

CAUTION: Be sure to insert the connector in until it locks. Then pull on it gently to make sure that it is locked.

2. DRIVER'S AIRBAG MODULE AND PRETENSIONER
1. How to disconnect:




1. Using a flat tip screwdriver, pry the push lock upward to unlock.




2. Pull the connector to disconnect from driver's side airbag module assembly or retractor assembly.

2. How to connect:




Connect the connector in the reverse order of disconnecting. At this time, be sure to insert the push until a connecting sound is heard.

CAUTION:
- Be sure to insert the connector in until it locks. Then pull it gently to make sure that it is locked.
- Be sure to push the push lock in securely.

NOTE: Connector can not be connected when the push is in lock position. To connect the connector, the push lock to unlock.

3. DRIVER'S AIRBAG (BETWEEN AIRBAG MAIN HARNESS AND ROLL CONNECTOR), PASSENGER'S AIRBAG
1. How to disconnect:




1. Push the slide lock (A) into the direction of arrow.




2. With the slide lock pushed, separate the connector.

CAUTION: Be sure to hold onto the connector and not wire when pulling the slide lock or disconnecting the connector.

2. How to connect:




Holding the connector, push it in carefully until a connecting sound is heard.

CAUTION: Be sure to insert the connector in until it locks. Then pull it gently to make sure that it is locked.

4. SIDE AIRBAG AND CURTAIN AIRBAG
1. How to disconnect:
1. Push the lock arm (A).




2. With the lock arm (A) pushed in, move the slide lock (B) in the direction of arrow.




3. With the slide lock moved, release the lock arm (back to its original position), and disconnect the connector.

CAUTION: Be sure to hold onto the connector and not wire when pulling the slide lock or disconnecting the connector.

5. FRONT SUB SENSOR, SIDE AIRBAG SENSOR, CURTAIN AIRBAG SENSOR AND SEAT POSITION SENSOR LH
1. How to disconnect:




Holding outer part (A), pull it in the direction of arrow.

CAUTION: Be sure to hold onto the connector and not wire when pulling the slide lock or disconnecting the connector.

1. How to connect:




Holding the connector, and push it in carefully until a connecting sound is heard.

CAUTION:
- Outer side (A) move back, and so do not put your hand on the outer part.
- Be sure to insert the connector in until it locks. Then pull it gently to make sure that it is locked.