Extension Case Oil Seal
Extension Case Oil SealINSPECTION
Make sure that the ATF does not leak from the joint of transmission and propeller shaft. If so, replace the oil seal.
REPLACEMENT
1. Lift-up the vehicle.
2. Clean the transmission exterior.
3. Remove the ATF drain plug to drain ATF.
CAUTION: After running the engine or after idling for a long time, the ATF is hot. Be careful not to burn yourself.
4. Tighten the ATF drain plug.
NOTE: Use a new gasket.
Tightening torque: 25 Nm (2.5 kgf-cm, 18 ft. lbs.)
5. Remove the rear exhaust pipe and muffler.
6. Remove the heat shield cover.
7. Remove the propeller shaft.
8. Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
9. Using the ST, install the oil seal.
ST 498057300 INSTALLER
10. Install the propeller shaft.
11. Install the heat shield cover.
12. Install the rear exhaust pipe and muffler.
13. Pour ATF into the oil charge pipe.
Recommended fluid: SUBARU ATF (PartNo. K0410Y0700), Idemitsu Apolloil ATF HP, Castrol Transmax J, Pennzoil Quakerstate Pennzoil ATF-J or Dexron III
NOTE: If the ATFs above are not available, use Dexron III.
Capacity: Fill the same amount of ATF drained.
14. Bleed the air of control valve.
15. Check the level and leaks of ATF.