With ABS
OPERATION1. While the ABS sequence control is performed, the operation of the hydraulic unit can be checked using the brake tester or pressure gauge after the hydraulic unit solenoid valve operation.
2. ABS sequence control can be started by Subaru Select Monitor.
ABS SEQUENCE CONTROL WITH SUBARU SELECT MONITOR
NOTE: In the event of any trouble, the ABS sequence control is not operated.
1. Connect the Subaru Select Monitor to data link connector under the driver's side instrument panel lower cover.
2. Turn the ignition switch to ON.
3. Set the Subaru Select Monitor switch to ON.
4. Set the Subaru Select Monitor to "Brake Control" mode.
5. When the "Function check sequence" is selected, the "ABS sequence control" will start.
6. Execute the following operations when the message "Press the brake pedal so that the brake pedal force is between 100 and 150 kgf" is displayed.
1 When the brake tester is used, press brake pedal pad with a force of 1,000 N (102 kgf, 225 lbs.).
2 When using the pressure gauge, press the brake pedal so as to make the pressure gauge indicate 3,500 kPa (36 kg/cm2, 511 psi).
7. "Press the [YES] key" will be displayed. Press the [YES] key.
8. The brake line being operated is displayed on the Subaru Select Monitor.
CONDITIONS FOR ABS SEQUENCE CONTROL
NOTE: The control operation starts from point A.
SPECIFICATION
CONDITIONS FOR COMPLETION OF ABS SEQUENCE CONTROL
When the following conditions develop, the ABS sequence control stops and ABS operation is returned to the normal control mode.
1. When the speed of at least one wheel reaches 10 km/h (6 MPH).
2. When the brake pedal is released during ABS sequence control and the stop light switch goes OFF.
3. After completion of ABS sequence control.
4. When malfunction is detected.