Restraints and Safety Systems

Airbag Connector

PROCEDURE

1. POWER SUPPLY, BUCKLE SWITCH AND OCCUPANT DETECTION SYSTEM HARNESS
1. How to disconnect:
1. Move the slide lock (A) in the direction of arrow.

2. With the slide lock (A) moved, separate the connector.

CAUTION: When pulling the slide lock or disconnecting the connector, be sure to hold onto the connector and not the wire.

2. How to connect:
Holding the connector (A), push it in carefully until a connecting sound is heard.

CAUTION: Be sure to insert the connector in until it is locked. Then pull on it gently to make sure that it is locked.

2. DRIVER'S AIRBAG MODULE AND PRETENSIONER
1. How to disconnect:

1. Using a flat tip screwdriver, pry the push lock upward to unlock.

2. Pull the connector to disconnect from the driver's airbag module assembly or retractor assembly.

2. How to connect:
Connect the connector in the reverse order of disconnecting. At this time, be sure to insert the push lock until a connecting sound is heard.

CAUTION:
- Be sure to insert the connector in until it is locked. Then pull on it gently to make sure that it is locked.
- Be sure to push the push lock in securely.

NOTE: Connector can not be connected when the push lock is in lock position. To connect the connector, set the push lock to unlock position.

3. DRIVER'S AIRBAG (BETWEEN AIRBAG MAIN HARNESS AND ROLL CONNECTOR), PASSENGER'S AIRBAG
1. How to disconnect:

1. Push the slide lock (A) into the direction of arrow.

2. With the slide lock pushed, disconnect the connector.

CAUTION: When pulling the side lock or disconnecting the connector, be sure to hold onto the connector and not the wire.

2. How to connect:
Holding the connector, push it in carefully until a connecting sound is heard.

CAUTION: Be sure to insert the connector in until it is locked. Then pull on it gently to make sure that it is locked.

4. SIDE AIRBAG AND CURTAIN AIRBAG
1. How to disconnect:
1. Push the lock arm (A).

2. With the lock arm (A) pushed in, move the slide lock (B) in the direction of arrow.
3. With the slide lock moved, release the lock arm (back to its original position), and disconnect the connector.

CAUTION: When pulling the side lock or disconnecting the connector, be sure to hold onto the connector and not the wire.

2. How to connect:
Holding the connector, push it in carefully until a connecting sound is heard.

CAUTION: Be sure to insert the connector in until it is locked. Then pull on it gently to make sure that it is locked.

5. FRONT SUB-SENSOR, SIDE AIRBAG SENSOR, CURTAIN AIRBAG SENSOR AND SEAT POSITION SENSOR
1. How to disconnect:
Holding the outer part (A), pull it in the direction of arrow.

CAUTION:
- The outer side (A) moves back, and so do not put your hand on the outer part.
- Be sure to insert the connector in until it is locked. Then pull on it gently to make sure that it is locked.